Does The "Transition Layer Count" Setting In Chitubox Actually Do

Transition Layer Count Chitubox. CHITUBOX Review and Guide Slicer Software for Resin 3D Printers What happens is that if the difference between bottom layer exposure and regular layer exposure is too big, the regular layers do not attach properly to the bottom layers. Transition Layer Count "0"? The default value in Chitubox 1.7 is "10"

Only set transition layer compensation Only enable bottom tolerance compensation Enable both transition layer compensation and bottom tolerance. Bottom tolerance compensates only affects bottom layers

Chitubox shrinkage compensation for resin 3Dprinting Liqcreate

It is basically the interval of seconds that the transition layers change per layer Enabling both layer transition and Bottom Tolerance compensation can lead to unexpected printing results. When transition layer compensation and bottom tolerance compensation are both enabled, the print result may be not be as good as expected

ChiTubox Best Support Settings For Resin Printing 3DprintingGeek. Bottom Tolerance Compensation only applies to bottom layers What happens is that if the difference between bottom layer exposure and regular layer exposure is too big, the regular layers do not attach properly to the bottom layers.

[CHITUBOX Pro]Lesson 4 Setting and Help YouTube. Transition layers as I understand it isn't in addition to the base layers, but rather a modulation effect of lowering the exposure gradually from base to your normal layer exposure values through whatever layer and time value you set. Image Blur Pixel : 2 ~ 8 , determines the number of pixels for edge transition, the higher level you select, the softer edge would be